With Father’s Day just around the corner, why not make these cute little cupcake toppers for your number 1 dad!

Father's Day Cupcake Topper

What you will need:

  • White sugarpaste and green modelling paste.
  • Letter Tappits
  • Rolling Pin
  • Paint brush
  • Water
  • Knife
  • Circle Cutters

Father's Day Cupcake Topper

 

 

1 – Roll out the white modelling paste to about 2mm thick and using the smooth edge of the circle cutter to cut out a circle and place to one side to dry

Father's Day Cupcake Topper

 

 

2 – Now roll out the green sugarpaste the same thickness and using the fluted edge of a smaller circle cutter, cut out a circle and place to one side to dry

Father's Day Cupcake Topper

 

 

3 – Roll out the mint green modelling paste slightly thinner (approx 1mm thick) and use the letter tappits to cut out DAD

Father's Day Cupcake Topper

 

 

4 – To make the tails of the rosette, roll out the mint green modelling paste again slightly thicker and cut 2 strips 1 inch wide by 2 inches long. Use a knife to cut a small triangle out of each one at the bottom

Father's Day Cupcake Topper

 

 

5 – Now using a paint brush and a small bit of water. Stick the white circle onto the green fluted circle. Then stick the letters on top

Father's Day Cupcake Topper

 

 

6 – To finish your cupcake pipe a swirl, place the tails on top and then stick the rosette ontop of the tails using a small amount of water

Father's Day Cupcake Topper

 

Happy baking!